The Fila HYDROREP hydro-repellent protection, solvent-based, penetrates deep into the material and protects it from degradation caused by water, limiting its absorption.
NON-POLISHED MARBLE AND GRANITE, NON-POLISHED STONE AND AGGLOMERATES, CEMENT, RECONSTRUCTED STONE
WHAT IT IS USED FOR
- Protects outdoor floors from water and humidity.
- Makes walls and coverings water-repellent.
- Ideal for exposed walls and concrete.
- Protects the joints.
- Defends from the degradation action of atmospheric agents.
THE ADVANTAGES
- It provides breathable, long-lasting and restorable protection.
- Does not alter the aesthetics of the materials.
- Does not yellow under any environmental or aging conditions.
- It has high penetration capabilities.
- It has a high yield.
- Prevents the formation of moss and mold.
- It is anti-efflorescence.
HOW TO USE
-
No dilution: ready for use.
-
Application: On a dry and clean surface, apply HYDROREP with a brush or other applicator regularly in two coats 8 hours apart. In the case of less absorbent stones (e.g. slate) a single coat of product is sufficient. To complete the cycle with an oleophobic protection: apply the FOB XTREME stain-resistant protector to replace the second coat of HYDROREP. The surface can be walked on after just 4 hours. The water-repellent protection is active after 24 hours. FOR PROFESSIONAL USE ONLY: on vertical surfaces, apply by spray (airless system), dosing the product to waste and using the appropriate PPE, as indicated in the safety data sheet.
ATTENTION
On natural stone, test the product on a small portion of the surface to
check for any color changes.
Do not apply the product outdoors if rain is forecast.
Does not protect against acid aggression .
INDICATIVE YIELD
With one liter of product I do:
- Natural stone 10/20 m²
- Cement 5 m²